Sonicwall Wrench Light. INDUSTRY SPOTLIGHT The SonicWall Story Total Security Summit If the only light blinking is the wrench, it is in safe mode If the test light stays on longer than two minutes after the reboot or comes on during normal functioning, it can be a symptom of firmware corruption, a power supply failure or a hardware problem
NSA 2650 System status LEDs — SonicWall Community from community.sonicwall.com
If the test light stays on longer than two minutes after the reboot or comes on during normal functioning, it can be a symptom of firmware corruption, a power supply failure or a hardware problem If you don't have a Sonicwall console cable, a Cisco console cable will work
NSA 2650 System status LEDs — SonicWall Community
The test light goes solid at boot, then after about 10 seconds, it starts blinking in this pattern: on (0.5 seconds), off (0.5 seconds), repeat Could someone confirm the suspicion that the double-blink indicates a heartbeat in the HA pair. I have two sites where the sonicwall that is in secondary/standby mode loses its brain and is booted into safe mode
SonicWall NSa 3700 Overview YouTube. Power / Power 1; Power 2; Test / Wrench; Service / Alarm; M1 & M2 I got a TZ370 HA and followed SonicWalls steps to configure it
SonicWall TZ270W Firewall. If the only light blinking is the wrench, it is in safe mode The device is in safe mode when the wrench/test light is blinking amber